Baby Trend Expedition sport Instrukcja Użytkownika Strona 4

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 6
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 3
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
5
6
Fig. 8
REAR WHEEL
Lean the stroller forward to rest on the front
wheel. To attach the rear wheels, push each
wheel's axle into the plastic corner tting as
shown in Fig. 8. Depress the metal lever on the
inside of the corner tting as you push the axle
into corner tting. When the wheel will not go
on any farther, release the lever. Check that the
wheel has locked into the corner tting by pulling
on the wheel. If not locked, lift upward on the
lever, push the wheel on farther and release lever.
Ensure that the wheels are firmly locked
into place. NEVER use the stroller if the
wheels are not locked into place, contact our
customer service department immediately at
1-800- 328-7363, between the hours of 8:00am
and 4:30pm PST, for assistance.
PARENT TRAY
To attach the parent tray, align the ttings on the
ends of the parent tray with the ttings on the
outsides of the handle. Hook the hole in the parent
tray. Pull outward on the opposite end while
pushing down on the tray until locked onto the
stroller handle. Please be careful not to pinch your
ngers when installing the parent tray. (Fig. 9) To
remove the parent tray, pull outward on one end of
the tray while lifting upward.
WARNING: Do not place
hot liquids or more than 3 pounds
in the parent tray. Serious burns or
unstable conditions could result.
CANOPY
To open the canopy: push forward on the front
edge of the canopy while holding the rear of
canopy in place. (Fig. 10a)
To fold the canopy: pull backwards on the front
edge. (Fig. 10b)
ASSEMBLY
CHILD TRAY (if equipped)
To attach the child tray: Insert the tray clip into
the tting on the strollers fold joint. Check the
tray clip locks into place. (Fig. 11) Push the angled
tray onto the post at the end of the right armrest,
while pressing downward on the snap button,
until locked into place. Rotate the tray downward
until latched onto the left armrest. Please check
that the snap button comes through and securely
latches the tray in place. (Fig. 12)
To open the child tray:
press inward on left side
tray release button and rotate upward on the tray.
Please see gure 13. Please note that you may
remove the tray completely by depressing the buttons
on each side while pulling forward on the tray.
INFANT CAR SEAT (if equipped)
To attach the Baby Trend Infant Car Seat, recline
the seat all the way back.
WARNING: Never jog or
run with your newborn in the car
seat position. Use for strolling only.
• Position the Infant Car Seat, facing toward the
rear of the stroller, so that the seat shell goes
into the front tray and latches into place. (Fig.
14) Check that the Infant Car Seat is rmly
locked onto the front tray before using.
Check that the front child tray is rmly
attached to the stroller armrests. Make sure
that the car seat locks into the front child tray.
Then turn tabs on stroller frame to lock the
front of the car seat into the stroller. (Fig. 15)
ASSEMBLY
Fig. 9
Fig. 10a
Fig. 10b
Open
Close
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Przeglądanie stron 3
1 2 3 4 5 6

Komentarze do niniejszej Instrukcji

Brak uwag